I just finished the assembly of the high resolution microscope (v7). After mounting the hardware, I assembled the electronic components as shown in the assembly tutorial (Assembly Instructions). As I’m using a sangaboard v0.5.4, which should come pre programmed, I directly tried to connect the microscope via ethernet to my laptop, after writing the Raspbian-OpenFlexure on the SD card of the Pi (I tried both versions). The microscope doesn’t show up in the nearby devices in Openflexure Connect and I don’t know how to troubleshoot this, did someone run into a similar issue or am I missing some steps required before the connection? Thanks
3 posts - 3 participants