Hello dear openFlexure community,
I’ve just finished assembling my microscope. However, I’m facing an issue where my objective lens is sticking out too far at the top, and I’m wondering what I might have done wrong. I purchased the full set from Sweden, so I didn’t 3D print anything myself everything came pre-assembled, including the objective.
Now I’m asking myself: do I perhaps need to adjust or calibrate something via the motor first? Because at the moment, it looks like the objective is protruding by about two millimeters. Has anyone encountered this before or knows what might be the cause? I couldn’t find anything about this in the forum at first glance.
4 posts - 2 participants