Hi, New here… I finally got the SangaBoards v0.5.3 (the last piece I was waiting for) in and was very excited to get everything running today with my OFM v7. Unfortunately, I’ve run into a few problems. I made it through a handful but I’m stuck on one rather important error… the motors don’t turn on.
I’ve read through forums and other things but don’t seem to see this exact issue. When I run ‘ofm rescue’ I get 2 “The serial port didn’t close cleanly” warnings, and then the error in red that says "No SangaStage device was found during port scanning.
The Sangaboard has two blue lights on. The red lights flash occasionally when you turn on the software on or boot up the Pi, but they don’t stay on (which I think is a good thing).
I installed the SangaBoard extension and upgraded the firmware. It said it was successful. The second in the extension area under system HW,FW, and py, don’t have any information next to them, however.
I’m at a loss. Any help would be amazing! Thank you!
6 posts - 2 participants