Hello everyone,
I’ve recently started my first build of the OpenFlexure v7. After getting the leg_test print bridges looking ok, I decided to do a couple test prints of the condenser and stage clips. While they seem to have printed well, I have noticed some pillowing of the top layers. If these were aesthetic prints, I would normally simply increase the amount of solid top layers, however as this is a microscope, I’m a bit hesitant as am not sure if this could mess with how everything fits together.
Has anyone had such issues with pillowing, or alternatively, is this even a problem I should worry about?
I’ve included some pictures of what I mean. Apologies if the pillowing is not super obvious as the PLA is white and the lighting is not the best!
P.S - I used a layer height of 0.1 mm and 15% infill
4 posts - 3 participants